Publicité
Les langues disponibles
Les langues disponibles
Menu item
Fad/Bal *
Loud
Volume
Adjust
Subwoofer
On/Off
Subwoofer
LPF *
9
Subwoofer
Level *
9
Subwoofer
Phase *
9
HPF
Beep
Amplifier
Gain *
10
SSM
Area Change
IF Band
*
7
If you are using a two-speaker system, set the fader level to <00>.
*
8
This adjustment will not affect the subwoofer output.
*
9
Displayed only when <On> is selected for <Subwoofer On/Off>.
*
10
The volume level automatically changes to "Vol 30" if you change to <Low Power> with the volume level set
higher than "Vol 30."
28
ENGLISH
Fad (fader) : F6 — R6 [ 0 ] : Press 5 / ∞ to adjust the front and rear speakers output
7,
*
8
balance. / Bal (balance) : L6 — R6 [ 0 ] : Press 4
and right speakers output balance.
On : Boost low and high frequencies to produce a well-balanced sound at a low volume
level. / Off : Cancels.
Level –5 — Level +5 [ Level 0 ] : Presets the volume adjustment level of
each source (except "FM"), compared to the FM volume level. The volume level will
automatically increase or decrease when you change the source. Before adjustment, select
the source you want to adjust. ("FIX" appears on the display if "FM" is selected as the
source.)
On : Turns on the subwoofer output. / Off : Cancels.
LOW 55Hz / MID 85Hz / HIGH 120Hz : Frequencies lower than 55 Hz/ 85 Hz/
120 Hz are sent to the subwoofer. / Off : Deactivates (all signals are sent to the rear
speakers).
Level 00 — Level 08 [ Level 04 ] : Adjusts the subwoofer output level.
0 Deg (normal) / 180 Deg (reverse) : Selects the subwoofer phase.
LOW 62Hz / MID 95Hz / HIGH 135Hz : Activates the High Pass Filter.
Frequencies lower than 62 Hz/ 95 Hz/ 135 Hz are cut off from the front/rear speakers. /
Off : Deactivates (all signals are sent to the front/rear speakers).
On / Off : Activates or deactivates the keypress tone.
Low Power : Vol 0 – Vol 30 (Selects if the maximum power of each speaker is less
than 50 W to prevent damaging the speakers.) / High Power : Vol 0 – Vol 50 /
Off : Deactivates the built-in amplifier.
Displayed only when the source is "FM" or "HD RADIO." For settings, see page 7.
US : When using in North/Central/South America. AM/FM intervals are set to
10 kHz/200 kHz. / EU : When using in any other areas. AM/FM intervals are set to
9 kHz/50 kHz. / SA : When using in South American countries where FM interval is
50 kHz. AM interval is set to 10 kHz.
Auto : Increases the tuner selectivity to reduce interference noises between adjacent
stations. (Stereo effect may be lost.) / Wide : Subject to interference noises from adjacent
stations, but sound quality will not be degraded and the stereo effect will remain.
Selectable setting, [ Initial: Underlined ]
/ ¢
to adjust the left
Publicité
