Publicité
Les langues disponibles
Les langues disponibles
PLEASE NOTE!
med milk back into milk container. This will clean the rest of cream in the top bowl.
After all procedures are finished, simply turn OFF the device and wait until motor
stops. Always check, whether the rubber washer is damaged or too much exten-
ded. In such cases please replace it with a new one.
SKIMMING REGULATION
The cream separator is factory adjusted with around 10 % of cream from whole milk volume
at milk temperature 35 °C. It is possible to adjust this percentage due to different conditi-
ons like density or volume of cream. Adjust hexagonal adjusting cream screw by turning it
(placed in the plastic partition in top bowl upper part).
• For more density cream – less volume, turn it towards right (clockwise)
• For less density cream – higher volume, turn it towards left (counter clockwise). In most
cases it is enough to turn the adjusting screw for ¼ of the rotation.
Cream adjusting screw details and function
TAKE CARE, NOT TO FIX THE ADJUSTING CREAM SCREW TOO DEEP. THIS CAN
CAUSE HARM TO THE SCREW COIL. DON'T UNSCREW THE REGULATION SCREW
TOO MUCH. THIS CAN CAUSE PROBLEMS WITH DISASSEMBLING THE PLASTIC
PARTITION AND THE TOP BOWL UPPER PART.
MAINTENANCE AND CLEANING
• All parts of the top bowl should be cleaned with hot water with some detergent.
• Rests of milk, cream or other impairs should be cleaned with soft duster or cleaning
brush. Especially take care to clean very precisely all the holes in top bowl upper part,
top bowl bottom part and in adjusting screw. For cleaning these parts, a cleaning brush
is strongly recommended! Other parts of the separator, which come in touch with milk,
should also be cleaned with hot water in which a detergent is added. Then rinse parts in
clean water.
• If milk or cream rests get dry, do not remove them with sharp objects or sharp duster. It
can easily happen, that the galvanic protection cover or plastic parts are damaged.
• Before cleaning cream separators housing, disconnect device from mains. Clean it first
with wet duster and then try it with dry duster. Take care, that water doesn't come into
the device.
Ensure, that no water comes in contact with the motor and other electric parts.
The device is protected against direct water access, please take care and avoid, that
water comes into the device.
Before cleaning, always disconnect the Cream Separator from the mains supply.
After you have finished skimming, pour approximately 1/2 l of skim-
- less cream volume and higher cream density
+ higher cream volume and less cream density
17
Publicité
