Publicité
Les langues disponibles
Les langues disponibles
5. Raise the hitch into position, feeding the end of the pull through the holes in
the hitch. Then pull the fasteners back through the frame rails and hitch brackets.
Repeat the same process on both frame rails.
7. Hitch will tend to slant at a slight angle downward, push hitch straight up into
frame and tighten hitch.
©2015 Cequent™ Performance Products, Inc. -
Printed in Mexico
6. Feed conical washer over pull wire, using the washer to hold the bolt in place remove
the pull wires and attach the hex nut. Tighten to hold hitch in place, repeat with all
fasteners.
8. Tighten all ½-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102
N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Sheet 5 of 18
75214NP
6-11-15
Rev. B
Publicité
