Télécharger Imprimer la page

Cequent Performance Products 75214 Instructions D'installation

Masquer les pouces Voir aussi pour 75214:

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

Cequent
Performance Products, Inc.
www.cequentgroup.com
Technical Assistance: 800- 632- 3290
TechnicalSupport@cequentgroup.com
To prevent SERIOUS INJURY, DEATH or PROPERTY DAMAGE:
ALWAYS read, understand and follow warnings and instructions
for your hitch BEFORE installation. Keep for future reference.
DO NOT cut, weld or modify this receiver.
CHECK all fasteners are tight and your hitch is securely mounted
to your vehicle periodically.
ALWAYS read, understand and follow all warnings and
instructions for your vehicle and for other accessories you will use
with your hitch BEFORE use.
LOAD the trailer heavier in front.
DO NOT exceed lower of towing vehicle manufacturer's rating or:
Hitch Type
Max Gross Trailer
Weight Carrying
4000 lb. (1816 kg)
Weight Distributing
4000 lb. (1816 kg)
ALWAYS wear your seatbelt.
SLOW DOWN when towing, NEVER exceed any posted speed limit.
If EXCESS SWAY occurs, take your foot off the gas pedal and hold
the steering wheel as steady as possible. DO NOT apply your
brakes and DO NOT speed up.
©2015 Cequent™ Performance Products, Inc. -
Installation Instructions
PART NUMBERS: 75214, 87684, 44766
Max Tongue
Weight
Weight
600 lb. (272 kg)
600 lb. (272 kg)
Printed in Mexico
LIMITED LIFETIME WARRANTY
Limited Lifetime Warranty ("Warranty"). Cequent Performance Products, Inc. ("We",
1.
"Us" or "Our") warrants to the original consumer purchaser only ("You" or "Your") that the
product will be free from material defects in both material and workmanship, ordinary wear
and tear excepted. The Warranty is valid only if (a) the products are returned to Us for
inspection and testing; (b) Our inspection discloses to Our satisfaction that any alleged
nonconformance are material and have not been caused by misuse, neglect, wear and tear,
improper installation, unsuitable storage, improper repair, alteration, or accident; and (c) the
products were installed, maintained and used in accordance with Our instructions. THE
WARRANTY IS MADE IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR
IMPLIED (OTHER THAN THE WARRANTY OF TITLE AS PROVIDED BY THE
UNIFORM COMMERCIAL CODE IN EFFECT IN MICHIGAN), INCLUDING
WITHOUT LIMITATION, ANY WARRANTIES OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE, SAID WARRANTIES BEING EXPRESSLY
DISCLAIMED.
2.
Obligations of Purchaser. To make a Warranty claim, contact Us at our principal address of
47912 Halyard Drive, Suite 100, Plymouth, MI 48170, 1-800-632-3290, identify the product
by model number, and follow the claim instructions that will be provided. Any returned
product that is replaced by Us becomes our property. You may be responsible for return
shipping costs. Please retain your purchase receipt to verify date of purchase and that You
are the original consumer purchaser. The product and the purchase receipt must be provided
to Us in order to process Your Warranty claim.
3.
Exclusive Remedy. Product replacement is Your sole and exclusive remedy under this
Warranty. We shall not be liable for service or labor charges incurred in removing or
replacing a product. IN NO EVENT WILL WE BE RESPONSIBLE FOR ANY INDIRECT,
SPECIAL, CONSEQUENTIAL OR PUNITIVE DAMAGES.
4.
Assumption of Risk. You acknowledge and agree that any use of the product for any
purpose other than the specified use(s) stated in the product instructions is at Your own risk.
5.
Governing Law. This Warranty gives You specific legal rights, and You also may have
other rights which vary from state to state. This Warranty is governed by the laws of the
State of Michigan, without regard to rules pertaining to conflicts of law. The state courts
located in Oakland County, Michigan shall have exclusive jurisdiction for any disputes
relating to this Warranty.
Rev 9/2014
Sheet 1 of 18
Scan for safe
towing tip, or visit
http://www.ceque
ntgroup.com/qr-
product.aspx
75214NP
6-11-15
Rev. B

Publicité

loading

Sommaire des Matières pour Cequent Performance Products 75214

  • Page 1 TechnicalSupport@cequentgroup.com product.aspx LIMITED LIFETIME WARRANTY Limited Lifetime Warranty (“Warranty”). Cequent Performance Products, Inc. ("We", “Us” or “Our”) warrants to the original consumer purchaser only ("You" or “Your”) that the To prevent SERIOUS INJURY, DEATH or PROPERTY DAMAGE: product will be free from material defects in both material and workmanship, ordinary wear •...
  • Page 2 ™ Cequent Performance Products, Inc. Installation Instructions www.cequentgroup.com 800-632-3290 PART NUMBERS: 75214, 87684, 44766 Technical Assistance: TechnicalSupport@cequentgroup.com Applications: Installation Time: 30 min. Years Make Models The time listed above is the average time for professional installers. If you do not...
  • Page 3 Always wear SAFETY GLASSES Installation Instructions ½-13 x 1.75 GR5 when installing hitch ② Qty. (4) Spacer PART NUMBERS: 75214, 87684, 44766 .250 x 1 x 3 2” [50.8] ③ Qty. (4) Conical washer Fastener Kit: 75214 F 6” [152.4] ½’’...
  • Page 4 1. Remove appearance panels on both side near the wheel well and covering the 2. Lower the exhaust at the rubber isolators on both sides of the exhaust. Support the frame rails, remove (2) hex nuts (M10 socket) on bottom of the frame rail and (2) exhaust to prevent damage to the vehicle.
  • Page 5 5. Raise the hitch into position, feeding the end of the pull through the holes in 6. Feed conical washer over pull wire, using the washer to hold the bolt in place remove the hitch. Then pull the fasteners back through the frame rails and hitch brackets. the pull wires and attach the hex nut.
  • Page 6 9. Raise exhaust back into position, spraying a lubricant or soapy water on the metal hanger rod. 10. Trim appearance panel removed in step 1 or return to owner. Working on one side at a time. Note: the entire rubber isolator can move on the metal rod to re-install Obtain owner permission before trimming.
  • Page 7 GARANTIE À VIE LIMITÉE Garantie à vie limitée (« Garantie »). Cequent Performance Products, Inc. (« Nous », « Notre ») garantit à l’acheteur initial seulement (« Vous », « Votre ») que le produit sera Pour prévenir les BLESSURES SÉVÈRES, FATALES ou les DOMMAGES exempt de vices de matières et de fabrication, exception faite de l’usure normale.
  • Page 8 ™ Cequent Performance Products, Inc. Instructions d’installation www.cequentgroup.com 800-632-3290 NUMÉROS DE PIÈCES : 75214, 87684, 44766 Assistance technique : TechnicalSupport@cequentgroup.com Applications : Durée de l'installation : 30 min. Années Marque Modèles La valeur indiquée ci-dessus est la durée moyenne des installeurs professionnels.
  • Page 9 Instructions d’installation ½-13 x 1.75 GR5 DE PROTECTION lors de l'installation de l'attelage. ② Qté (4) Espaceur NUMÉROS DE PIÈCE : 75214, 87684, 44766 .250 x 1 x 3 2” [50.8] ③ Qté (4) Rondelle conique Visserie : 75214 F ½’’...
  • Page 10 1. Enlever les panneaux décoratifs des deux côtés près du passage de roue qui 2. Abaisser l’échappement au niveau des isolateurs en caoutchouc des deux côtés de recouvrent les longerons : ôter deux (2) écrous hexagonaux (douille M10) dans le l'échappement.
  • Page 11 5. Soulever l'attelage en position, en acheminant l'extrémité du fil de tirage à 6. Enfiler la rondelle conique sur le fil de tirage, puis utilisant la rondelle pour maintenir travers les trous de l'attelage. Puis repousser la visserie dans les longerons et les le boulon en place, retirer les fils de tirage et attacher l'écrou hexagonal.
  • Page 12 9. Soulever l'échappement pour le remettre en position, vaporisant un lubrifiant ou de l'eau savonneuse 10. Découper le panneau décoratif enlevé à l'étape 1 ou le retourner sur la tige du support métallique. Travailler d'un côté à la fois. Remarque : Étant donné que l'isolateur en au propriétaire.
  • Page 13 GARANTÍA LIMITADA DE POR VIDA Garantía limitada de por vida ("Garantía") Cequent Performance Products, Inc. ("nosotros", Para evitar DAÑOS DE GRAVEDAD, A LA PROPIEDAD O LA MUERTE: "nos" o "nuestro/a/s") garantiza al comprador original únicamente ("usted" o "su/s") que el producto estará...
  • Page 14 ™ Cequent Performance Products, Inc. Instrucciones de instalación www.cequentgroup.com Asistencia técnica: 800-632-3290 NÚMEROS DE PARTES: 75214, 87684, 44766 TechnicalSupport@cequentgroup.com Aplicaciones: Tiempo de instalación: 30 min. Años Marca Modelos El tiempo indicado anteriormente es el tiempo promedio para instaladores 2015-Actual* Ford Edge profesionales.
  • Page 15 Instrucciones de instalación ½-13 x 1.75 GR5 SEGURIDAD al instalar el enganche ② Cant. (4) Espaciador NÚMEROS DE PARTE: 75214, 87684, 44766 .250 x 1 x 3 2” [50.8] ③ Cant. (4) Arandela cónica Kit de fijadores: 75214 F ½”...
  • Page 16 1. Retire los paneles de apariencia en ambos lados cerca del receptáculo de la rueda y 2. Baje el escape en los aisladores de goma en ambos lados del tubo de escape. Apoye el que cubren los largueros del bastidor, retire (2) tuercas hexagonales (cubo M10) en la escape para evitar daños al vehículo.
  • Page 17 5. Levante el enganche a su posición, pasando el alambre de insertar por los orificios 6. Inserte la arandela cónica sobre el alambre de insertar, usando la arandela para mantener en el enganche. Luego hale los fijadores de nuevo a través de los largueros del el perno en su lugar, retire los alambres de insertar y coloque la tuerca hexagonal.
  • Page 18 9. Levante el escape de nuevo a su posición, rociando lubricante o agua jabonosa en el vástago del colgante de 10. Recorte el panel de apariencia que se retiró en el paso 1 o devuélvalo metal. Solo trabaje en un lado a la vez. Nota: todo el aislante de goma se puede mover en el vástago de metal al propietario.

Ce manuel est également adapté pour:

8768444766