Table des Matières
Publicité
6
Fig. 1
Fig. 2
02966
A
To Level Mower
Ensure tires are properly inflated to the PSI shown on tires.
If tires are over or under inflated, it may affect the appear-
ance of your lawn and lead you to think the mower is not
adjusted properly.
VISUAL SIDE-TO-SIDE ADJUSTMENT
1. With all tires properly inflated and if your lawn appears
unevenly cut, determine which side of mower is cutting
lower.
NOTE: As desired, you can raise the low side of mower or
lower the high side.
2. Go to side of mower you wish to adjust.
3. With a 3/4" or adjustable wrench, turn lift link adjustment
nut (A) to the left to lower the mower, or, to the right to
raise the mower (Fig. 1).
NOTE: Each full turn of adjustment nut will change mower
height about 3/16" (4,7 mm).
4. Test your adjustment by mowing some uncut grass and
visually checking the appearance. Readjust, if necessary,
until you are satisfied with the results.
PRECISION SIDE-TO-SIDE ADJUSTMENT
1. With all tires properly inflated, park tractor on level ground
or driveway.
CAUTION: Blades are sharp. Protect your hands with gloves
and/or wrap blade with heavy cloth.
2. Raise mower to its highest position.
3. At both sides of mower, position blade at side and mea-
sure the distance (A) from bottom edge of blade to the
ground. The distance should be the same on both sides
(Fig. 2).
4. If adjustment is necessary, see steps in Visual Adjustment
instructions above.
5. Recheck measurements, adjust if necessary until both
sides are equal.
A
A
82
Fig. 3
B
Fig. 4
B
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level side-to-side.
To obtain the best cutting re sults, the mower blades should be
adjusted so the front tip is 1/4" to 3/8" (6,3 to 9,5 mm) lower
than the rear tip when the mower is in its highest position.
CAUTION: Blades are sharp. Protect your hands with gloves
and/or wrap blade with heavy cloth.
•
Raise mower to highest position.
•
Position any blade so the tip is pointing straight forward.
Measure distance (B) to the ground at front and rear tip
of the blade (Fig. 3).
•
If front tip of blade is not 1/4" to 3/8" (6,3 to 9,5 mm) lower
than the rear tip, go to the front of tractor.
•
With an 11/16" or adjustable wrench, loosen jam nut (A)
several turns to clear adjustment nut (B).
•
With a 3/4" or adjustable wrench, turn front link adjust-
ment nut (B) clockwise ( ) (tighten) to raise the front of
mower, or, counterclockwise ( ) (loosen) to lower the
front mower (Fig. 4).
02548
B
A
Publicité
Table des Matières
