Hitachi NC 40G Manuel D'instructions Et De Sécurité page 19

To continue nailing in a separate location, move the
nailer along the workpiece, repeating steps 1 - 4 as
required.
Push lever
HOW TO USE THE NOSE CAP
WARNING
Before attaching or removing the nose cap, be
sure to take your finger off the trigger and remove
the fuel cell and battery.
NOTE:
Keep the nose cap on when driving nails into slippery
materials such as thin steel sheets.
Remove the nose cap when driving nails into wood.
REMOVING/ATTACHING THE NOSE CAP:
The nose cap is attached simply by pressing it onto the
push lever.
To remove, insert a screwdriver or similar into the gap
between the nose cap and the push lever and lever off.
Push lever
Nose cap
Driver
Trigger
Push lever
Nose cap
— 19 —
CLEARING A JAM
WARNING
Handle with care to avoid burning yourself, since
the nails and nose may become very hot.
If nails are jammed in firing head, remove it, and adjust the
nailing in the following order.
1 Remove the fuel cell and the battery from the Nailer.
2 Lock follower back in magazine and remove fasteners.
3 Loosen the knob and lower toward the handle.
4 Pull magazine away from the firing head, and clear
jam.
5 Connect the fuel cell and the battery to the Nailer.
ALWAYS WEAR SAFETY GLASSES.
English
Fuel cell
Battery
Knob