At the end of istallation, connect the wiring to
the terminal (power supply connector, 6.3 Board
description, page 10).
Fig. 13
7.3 Blower
7.3.1 Blower installation
Not usable in versions with double filter
for air renewal.
Pay attention to the voltage used to power
the circuit. Depending on requirements
use the correct power supply kit.
The blower kit should be assembled
according to the instructions to ensure a
correct air circulation inside the housing.
Open the housing as described in the relative
chapter (6.1 Housing opening, page 9).
Fix the blower using the corner bracket and screws.
The VERSO housing is provided with a single
installation location for the blower (01). In VERSO
COMPACT housing you can choose between two
different installation locations (02).
01
02
Fig. 14
14
8 Cleaning
8.1 Cleaning the window and
plastic parts
Avoid ethyl alcohol, solvents,
hydrogenated hydrocarbide, strong acid
and alkali. Such products may irreparably
damage the surface.
We recommend using a soft cloth with neutral soap
diluted with water or specific products to clean the
lenses.
9 Information on disposal
and recycling
The European Directive 2012/19/EU on Waste
Electrical and Electronic Equipment (WEEE)
mandates that these devices should not be disposed
of in the normal flow of municipal solid waste, but
they should be collected separately in order to
optimize the recovery stream and recycling of the
materials that they contain and to reduce the impact
on human health and the environment due to the
presence of potentially hazardous substances.
The symbol of the crossed out bin is
marked on all products to remember this.
The waste may be delivered to appropriate
collection centers, or may be delivered free of
charge to the distributor where you purchased
the equipment at the time of purchase of a new
equivalent or without obligation to a new purchase
for equipment with size smaller than 25cm (9.8in).
For more information on proper disposal of these
devices, you can contact the responsible public
service.
MNVCHPVB_2222_EN