Videotec VERSO Mode D'emploi page 15

7 Accessories
For further details on configuration and
use, refer to the relative manual.
7.1 Heater
7.1.1 Heater installation
Open the housing as described in the relative
chapter (6.1 Housing opening, page 9).
Fix the heater kit to the prearranged points on the
body of the housing.
The pre-wired heating element (01) should be
positioned between the 2 dissipators (02) before
attachment to ensure contact and hence guarantee
correct heat transmission.
01
Fig. 9
Pass the heating wiring into the provided seatings.
Fig. 10
Reposition the internal slide and tighten the screws
that had been loosened previously.
MNVCHPVB_2222_EN
7.2 Camera power supply
7.2.1 Camera power supply installation
Usable power supplies:
• IN from 100Vac up to 240Vac, 50/60Hz - OUT
12Vdc, 1.25A
• IN 230Vac, 50Hz - OUT 24Vac, 50Hz, 400mA
Fig. 11
Open the housing as described in the relative
chapter (6.1 Housing opening, page 9).
02
Position the camera power supply in the provided
seating, parallel to the support ribs. Fix the power
02
supply to the body of the housing using the corner
bracket and screws supplied in the camera power
supply kit.
Fig. 12
Pay attention to the voltage used to power
the circuit. Depending on requirements
use the correct power supply kit.
Camera power supply.
13