Tectro TS 226 Manuel D'utilisation page 121

4. Push the On/off button
your settings. Push the On/off button
G
NOTE!
The FAN ONLY mode cannot be used to control the temperature. In this mode, only steps 1, 3 and
4 are applicable.
DRY Operation
1. Push the Mode button
2. Push the p or q button (
3. Push the On/off button
mode. Push the On/off button
G
NOTE!
Due to the difference of the set temperature of the unit and the actual indoor temperature, the
air conditioner when in DRY mode will automatically operate many times without running the
COOL and FAN mode.
TIMER Operation
Push Timer on/off button (
set by the remote controller for the timer function is limited to a period of between 0.5 and less than 24
hours.
1. To set the STARTING time.
1.1 Push the Timer on button
the starting operation and the signal "h" will be shown on the Timer display area. You are now ready
to reset the time to START the operation.
1.2 Push the Timer on button
1.3 After setting the Timer on ,there will be half a second delay before the remote controller transmits the
signal to the air conditioner.
2. To set the STOPPING time.
2.1 Push the Timer off button
time for the timer off operation in hours will be shown on the Timer display area. You are now ready
to reset the time of the STOP operation.
2.2 Push the Timer off button
2.3 After setting the Timer off, there will be half a second delay before the remote controller transmits the
signal to the air conditioner.
Example of timer setting
To start the air conditioner in 6 hours.
TIMER ON
1. Press the TIMER ON button, the last setting of starting operation time and the sig-
nal "h" will show on the display area.
2. Press the TIMER ON button to display "6:0h" .
Start
3. Wait for one second and the digital display area will show the temperature again.
Off
The "TIMER ON" indicator remains on and this function is activated.
6 h
Combined timer
(setting both ON and OFF timers simultaneously)
. The operation lamp lights and the air conditioner starts to operate as per
again to stop this unit operation.
to select DRY.
and ) to set the desired temperature.
. The operation lamp lights and the air conditioner starts to operate in the DRY
again to stop this unit operation.
and ) to set the on and off times of the unit. The effective operation time
, then the remote controller display shows ON TIMER, the last set time for
again to set desired unit start time.
and the remote controller display will show OFF TIMER and the last set
again to set the time you want to stop the operation.
4
121