Bimar HC509 Notice D'instructions page 18

USE
Note: before assembling the appliance, ensure that it is not plugged into the mains.
First use
Warning:run the appliance for at least a few hours to eliminate the "new smell" and any oil
residue from the manufacturing process.During this operation, ventilate the room well to
eliminate the "new smell" that is given off.
Model with switches and with room thermostat regulation (type AMA07)
The heater is equipped with the following adjustment devices:
Switch (A) to turn on the fan (turbo function), turns on in pos.(
-
Switch (B) to adjust the power 750W = heat with low power consumption, turns on in pos.
-
(750) or turns off in pos.(●).
Switch (C) to adjust the power 1250W = heat with low power consumption, turns on in
-
pos.(1250) or turns off in pos.(●).
Switch (B+C) to adjust the power 2000W = immediate heat, turns on in
-
pos.(750+1250/2000W) or turned off in pos.(●).
The thermostat (D) regulates the appliance based on the surrounding ambient
-
temperature: it heats continuously until the set temperature is reached, and then it heats
only when the temperature decreases and for the period of time needed to bring it back
up to the set temperature.Use the respective knob: if turned fully in an anticlockwise
direction, the fan heater stays off (MIN), if fully turned clockwise it is set to the maximum
temperature (MAX); the heater runs at intervals when set to the settings in between.
18
) or turns off in pos.(●).