PROEL FLASH8A V2 Notice D'utilisation page 19

"punch", or to reduce the low frequency rise when the speaker is set near walls or on floor as stage monitor.
8. HIGH control
This control gives you up to 6 dB boost or cut at 8 KHz with a "SHELVING" curve shape. Use it to add or reduce the sound
"clarity" and "brightness".
9. SIGN/LIMIT indicator
GREEN LED illuminates to indicate the presence of the signal at the amplifier input.
RED LED illuminates when the internal amplifier's output is limited. When this LED flashes reduce the input signal
level.
10. ON indicator
GREEN LED: when lighted indicates amplifier has been turned on and AC power is available.
11. POWER switch
Speaker is "ON" when the switch is in the "I" position, use this switch to set the speaker power to ON or OFF.
NOTE: When you shut down your equipment, turn off the speaker first. When powering up, turn on the speaker last.
12. FUSE holder
Here is placed the mains protection fuse.
Please follow the instructions on page 11 of this manual to replace it.
13. AC~ socket
Here's where you plug in your speaker's mains supply cord. You should always use the mains cord supplied with the
speaker. Be sure your speaker is turned off before you plug the mains supply cord into an electrical outlet.
14. PRODUCT LABEL
In this label are written the most important information about the loudspeaker: model, line voltage, consumption, serial
number.
19