6.5 Acoustic signals
Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
and
start to flash and the
display is blank.
2. Press
• The indicators
and
• The indicator
flash.
• The display shows the current
setting:
= Acoustic signal off.
3. Press
to change the setting.
= Acoustic signal on.
4. Press the on/off button to confirm
the setting.
6.6 How to set the colour of
the TimeBeam
It is possible to change the colour of the
TimeBeam to match the colour of the
kitchen floor. There are several colours
available. The TimeBeam can also be
deactivated.
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
and
until
,
,
,
,
,
,
,
go off.
continues to
and
until
,
,
,
,
and
start to flash and the
display is blank.
2. Press
.
• The indicators
and
• The indicator
flash.
• The display shows a number and
the letter C. Each number refers
to a different colour.
–
= TimeBeam
deactivated.
3. Press
again and again to change
the colour.
• You can see the different colours
on the kitchen floor.
4. Press the on/off button to confirm
the setting.
6.7 AirDry
AirDry improves the drying results with
less energy consumption.
While the drying phase
operates, a device opens the
appliance door. The door is
then kept ajar.
CAUTION!
Do not try to close the
appliance door within 2
minutes after automatic
open. This can cause
damage to the appliance.
AirDry is automatically activated with all
programmes excluding
To improve the drying performance refer
to the XtraDry option or activate AirDry.
ENGLISH
37
,
,
,
go off.
continues to
.