Télécharger Imprimer la page

Gaggenau AW 220190 Mode D'emploi Et Notice De Montage page 23

Masquer les pouces Voir aussi pour AW 220190:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 35
Proper use
Clean the extractor hood thoroughly before
using for the first time.
Before cleaning and servicing the extractor
hood, isolate it from the power supply by pulling
out the mains plug or switching off the fuse.
Bulbs (especially halogen bulbs) become very
hot during operation. Even some time after the
appliance has been switched off, there is still a
risk of burns!
Before changing bulbs, isolate the extractor
hood from the power supply and leave the bulbs
to cool down!
Do not operate the extractor hood without bulbs
inserted.
Always switch on the extractor hood if a
hotplate is being used. If the extractor hood is
not switched on, condensation may form. As a
result, the appliance may corrode.
Do not place any objects
on the extractor hood.
RISK OF FIRE
Do not flambé under the extractor hood or work
with a naked flame. When switched on, the
extractor hood draws flames into the filter. There is
a risk of fire due to deposits on the grease filter!
Do not leave pans, frying pans or deep-fat
fryers unattended if you are cooking food with
oils or fats, e.g. chips. Overheated oils or fats
can easily ignite!
A risk of fire can be prevented by cleaning the
grease filters regularly and changing the
activated-carbon filter in good time.
Never operate the extractor hood without
grease filters.
Correct installation
Check the manufacturer's specifications for the
cooker to determine whether an extractor hood
can be operated over it.
If the manufacturer of the cooker has not
specified any significant safety distances, the
following minimum distances apply
550 mm between electric hob and the lower
edge of the extractor hood, Fig. 1.
650 mm between gas hob (upper edge of pan
support) and the lower edge of the extractor
hood, Fig. 1.
If various cookers are used, the greatest
indicated distance applies.
The width of the extractor hood must
correspond to the width of the cooking area.
The extractor hood must not be installed over a
solid fuel heating appliance which may be a fire
risk (e.g. flying sparks) unless the heating
appliance has a closed, non-detachable cover
and the country-specific regulations are
observed. This restriction does not apply to gas
cookers and gas hobs.
To avoid damaging the hob, cover it when
installing the extractor hood.
23

Publicité

loading

Ce manuel est également adapté pour:

Aw 220170Aw 220120Aw 221170Aw 221190Aw 221120