EINHELL TP-MX 18-2 Li BL Instructions D'origine page 16

When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
5.2 Battery capacity indicator (Fig. 2/Item e)
Press the button for the battery capacity indicator
(d). The battery capacity indicator (e) will indicate
the charge status of the battery by means of 3
LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
5.3 Fitting the stirrer (Fig. 4-5):
Screw the two parts of stirrer, part (6a) and part
(6b) tightly together. Then screw the stirrer (6) into
the stirrer mount (4). Use two open-ended span-
ners to do so. Use one open-ended spanner (5a)
to hold the stirrer mount (4) fi rmly while tightening
the stirrer (6) with the other open-ended spanner
(5b). To remove the stirrer, proceed in reverse
order.
6. Operation
6.1 On/Off switch (Fig. 6/Item 1)
Switching on:
Press the locking button for On/Off switch (3) and
the On/Off switch (1).
Anl_TP_MX_18_2_Li_BL_SPK13.indb 16 Anl_TP_MX_18_2_Li_BL_SPK13.indb 16
GB
Switching off :
Release the locking button for On/Off switch (3)
and the On/Off switch (1).
6.2 Speed controller (Fig. 7/Item 2)
You can select the speed by turning the speed
controller (2). You can choose from 7 speed set-
tings.
Plus direction: Higher speed
Minus direction: Lower speed
6.3 Defi ning the speed range (Fig. 8/Item 7)
The gear selector switch (7) enables you to work
within a specifi c speed range.
Switch position, setting 1 (A)
Speed range: high torque, low speed
Switch position, setting 2 (B)
Speed range: low torque, high speed
Note! Change the gear only when the drill is at a
standstill. If you fail to observe this point, the gea-
ring may be damaged.
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the battery pack before starting
any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
- 16 -
15.11.2022 09:14:24 15.11.2022 09:14:24