Maico EVN 22 Instructions De Montage Et Mode D'emploi page 14

UK │ 6. Safety instructions
● Assembly and electrical con-
nection may only be underta-
ken by trained specialists in
accordance with Chapter 2.1.
● With electrical and unit
installation, the relevant
regulations must be observed,
particularly DIN VDE 0100
with the corresponding parts.
In rooms with baths or shower
units, for example, this would
be Part 701.
● Only connect unit to
permanently wired electrical
installations with NYM-O or
NYM-J, (0.75 x 1.5 mm²)
cables. Use suitable, flexible
connecting cable if the unit is
installed in a swivel window.
Additionally, a mains isolation
device with contact openings
of at least 3 mm at each pole
must be installed.
● The unit may only be
operated using the voltage
and frequency shown on the
rating plate.
● Only operate the unit when it
is completely installed.
● Disconnect the unit
completely from the power
supply before removing the
terminal box cover [4].
● Ensure a sufficient fresh air
supply intake.
12
● Modifications and alterations
to the unit are not permitted
and release the manufacturer
from any guarantee and
liability.
6.2 Safe and correct practices
during operation
Danger of injury in case
of objects in the impeller.
Do not insert any objects
in the unit.
Danger of injury from
rotating impeller. Do not
get too close to the unit,
to avoid hair, clothing or
jewellery being drawn into
the unit.
● Risks for people (including
children) with reduced
physical, sensory or mental
capabilities or a lack of
knowledge. Fan may only be
installed, commissioned,
cleaned and maintained by
people who can safely
recognise and avoid the risks
associated with this work.
Children must not play with
the unit.