Publicité
Les langues disponibles
Les langues disponibles
the Pan, Tilt, color, Gobo1, R-Gobo, Gobo2, Prism, R-Prism, or Focus. Once the position
has been selected, press the ENTER button to setup. To go back to the functions without
any change press the MENU button again. Hold and press the MENU button about one
second or wait for one minute to exit the menu mode.
4. HOW TO CONTROL THE UNIT
You can operate the unit in three ways:
1. By master/slave built-in preprogram function
2. By easy controller
3. By universal DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be effected at once. Every time you turn the unit on, it will show "LED-MS50" on
the display and move all the motors to their 'home' position and you may hear some noises
for about 20 seconds. After that the unit will be ready to receive DMX signal or run the built
in programs.
4.1 MASTER/SLAVE BUILT IN PREPROGRAMMED FUNCTION
By linking the units in master/slave connection, the first unit will control the other units to
give an automatic, sound activated, synchronized light show. This function is good when you
want an instant show. You have to set the first unit in master mode Show Mode and select
show 1 or show 2 or show 3 or show 4 mode. Its DMX input jack will have nothing plugged
into it, and Its master LED will be constantly on and sound LED will flash to the music. The
other units will have to set in slave mode and select Slave 1 (normal) or Slave 2 (2 light
show) mode, Their DMX cables plugged into the DMX input jacks (daisy chain) and the
slave led lights will constantly on.
2-light show
In slave mode, Slave 1 means the unit works normally and Slave 2 means 2-light show. In
order to create a great light show, you can set Slave 2 on the second unit to get contrast
movement to each other, even if you have two units only.
4.2 EASY CONTROLLER
The easy remote control is used only in master/slave mode. By connecting to
the 1/4" microphone jack of the first unit, you will find that the remote control
on the first unit will control all the other units functions press the MENU button
again.
33B
Publicité
