Nicols BIRDY 250 LED Manuel D'utilisation page 27

3. HOW TO SET THE UNIT
3.1 CONTROL PANEL
Display: To show the various menus and the selected functions
LED
DMX
MASTER
SLAVE
SOUND
Button
MENU
DOWN
UP
ENTER
Only for remote control: Connecting with CA-8/CA-9/CA-9RTX to control the unit for Stand
by, Function and Mode function.
Mains input: Connect to supply mains power.
DMX input/output: For DMX512 link, use 3/5-pin XLR plug cable to link the unit together.
3.2 MAIN FUNCTION
To select any of the given functions, press the MENU button up to when the required one is
showing on the display. Select the function by ENTER button and the display will blink. Use
DOWN and UP button to change the mode. Once the required mode has been selected,
press the ENTER button to setup, to go back to the functions without any change press the
MENU button again. Hold and press the MENU button about one second or wait for one
minute to exit the menu mode.
The main functions are showing below:
On DMX input present
On Master Mode
On Slave Mode
Flashing Sound activation
To select the programming functions
To go backward in the selected functions
To go forward in the selected functions
To confirm the selected functions
26B