Novy Vision 7830 Instructions D'installation page 13

GENERAL
These are the mounting instructions for the Novy unit shown on the cover. The user manual is delivered separately with
this unit. Carefully read these instructions before installing and commissioning this unit. It is recommended to have one
or more qualified persons carry out the installation.
This manual makes use of a number of symbols. The meaning of these symbols are given below.
Symbol
Safety
Observe the following mounting and safety tips for mounting:
• The installation and electrical connection of the unit shall be carried out by an authorised expert.
• The manufacturer does not accept any responsibility for any damage resulting from faulty building in or connection.
• Carefully take the unit from the packaging and check it for damage before mounting.
• Do not mount the unit in case of any damage.
• Check if all mounting materials have been supplied using the drawings at page 2.
• The unit is intended for household use only (preparation of food) excluding any other domestic, commercial or in-
dustrial use.
• Safety can only be guaranteed if the unit is connected to an earth wire in accordance with the required regulations.
• Do not use an extension cord for connecting to the electricity grid.
• Replace defective or damaged parts only with original Novy parts.
• Replace a damaged power cable with an original Novy power cable.
Important before mounting
Page 2 of these mounting instructions show the mounting drawings. Observe the following mounting tips before starting
the mounting activities:
• For easier mounting of the wall unit, it is recommended to do this with at least 2 persons.
• Make sure that the ceiling has sufficient load bearing capacity.
• Position the wall socket in such a way that it is behind the ceiling unit.
INSTALLATION
Follow the mounting drawings on page 2.
Check the mounting materials against drawing 1.
1
2 Determine the mounting height 'h' above the hob:
• Recommended mounting height with induction, electric or ceramic hob (Hmin-Hmax) (mm): 500 - 750
• Mounting height with a gas hob (Hmin-Hmax) (mm): 650-750
3 • The height at which the 2 mounting hooks are mounted is determined by: chosen height "h" + 480 mm. Draw a
level horizontal line at this height.
• Drill the holes in the wall using an 8 mm drill. The distance between the 2 holes is 510 mm (ensure that hood is
positioned centrally above the cooker plate).
4
Position the 2 mounting hooks in the wall. The suspension can be levelled by turning the adjustment screws (below).
This can be done beforehand, or after the extraction hood has been removed from the wall.
5
Turn motor so exhaust faces backwards:
As standard, the exhaust of the motor faces upwards. If required, the motor can be turned so the exhaust faces to the
rear. In order to do this, follow the instructions below.
A First open the bottom plate and remove the filters from the hood. A cable is connected to the motor with a
connector. First disconnect the connector from the motor. Afterwards, unscrew the six screws from the upper side
and the six screws on the rear side.
B. The entire motor plate including motor can now be turned so the motor exhaust is directed towards the rear.
C. Tighten all 12 screws. In order to be able to reconnect the cable back to the motor using the connector, you must
first loosen the pull-relief from the cable. The pull-relief can be found next to the access hatch in the hood. Ensure
there is enough cable length to allow the connector to be reconnected to the motor. Make sure that the pull-relief
is locked.
D. Use the dimensional drawing to ascertain the correct position of the exhaust duct.
6
Mount the upper spacer bracket at 20mm between the ceiling and the centre point of the holes in the bracket. Make
Meaning
Indication
Warning
Action
Explanation of an indication on the
hood
This symbol indicates an important tip
or a dangerous situation.
EN 13