Samsung SCC-C7453N Guide D'utilisation page 13

INSTALLATION
1. Press the SNAP FIT of the ADAPTOR in the HOUSING to open the ADAPTOR
part, and then insert all external cables into the HOUSING. Secure the HOUSING
on the PIPE or MOUNT by turning it clockwise.
(Secure two components tightly, to avoid loosened HOUSING.)
PIPE OR
MOUNT
HOUSING
EXTERNAL
CABLE
ADAPTOR
2. Connect external cables to the CONNECTORS(ALARM IN, POWER, RS-485,
ALARM OUT) and connect the CONNECTOR to the ADAPTOR.
Insert the cable into the FRAME SET, and close the ADAPTOR.
POWER INPUT
RS-485
ALARM IN

M
Then, wrap the BNC JACK with the INSULATION TUBE, and use an insulation tape
to seal up the end of the INSULATION TUBE so that the BNC JACK does not
protrude outside of the INSULATION TUBE coating.
For more information about cable connection, refer to Connecting the adaptor
cable. (page 21)
SNAP-FIT
HOUSING
ALARM OUT
EXTERNAL
CABLE
PIPE OR
MOUNT
HOUSING
ADAPTOR
BNC JACK
INSULATION
TUBE
English _13