Hilti NURON HDE 500-22 Mode D'emploi Original page 16

Status Dispensing-wheel
setting/symbol
LED shows red
Discard function
Repeat function
Measured dispensing
LED flashes red
Discard function
Repeat function
Measured dispensing
4 Technical data
Weight without battery
Rated voltage
Storage temperature
Ambient temperature for operation
4.1 Battery
Battery operating voltage
Weight, battery
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
5 Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 6
5.2 Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
8 English
Meaning
Discarding/dispensing aborted.
Discarding/dispensing volume not fully ejected.
The volume left in the pack is not sufficient for the
next dispensing operation or repeat of the previous
dispensing operation as set by means of the dispensing
wheel, or for the discharge function.
2293683
HDE 500­22
1.9 kg
(4.2 lb)
21.6 V
−40 ℃ ... 85 ℃
(−40 ℉ ... 185 ℉)
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
21.6 V
See the end of these
operating instructions
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
−20 ℃ ... 40 ℃
(−4 ℉ ... 104 ℉)
−10 ℃ ... 45 ℃
(14 ℉ ... 113 ℉)
*2293683*