Operation; Removing The Rechargeable Battery From The Cordless Screw Driller/Inserting It; Inserting Tool Into The Quick-Action Drill Chuck/Removing It; Rotating Direction Switch (With Activation Lock) - BASETech 1429464 Mode D'emploi Original

8. Operation

a) Removing the Rechargeable Battery from the Cordless Screw Driller/Inserting It
• To remove the rechargeable battery from the cordless screw driller, keep the two unlocking buttons (6) on the left
and right of the cordless screw driller pushed and pull the rechargeable battery out downwards.
• To insert the rechargeable battery, push it into the rechargeable battery holder in the correct alignment until it latches.
b) Inserting Tool into the Quick-Action Drill Chuck/Removing It
• Put the rotating direction switch (4) in the middle position to block the
on/off switch (8).
• Open the quick-action drill chuck by turning it counter-clockwise to the left
(viewed from the front) (A).
• Insert the desired tool into the drill chuck. The diameter must be at least
1 mm, and at most 10 mm.
• Tighten the quick-action drill chuck by turning it clockwise to the right
(viewed from the front) (B).
T o fasten the tool (e.g. a drill) firmly in the quick-action drill chuck,
it should be inserted at least 1 cm deep (e.g. small drills). Drills
with a larger diameter should be inserted more deeply into the
quick-action drill chuck so that they can be fastened securely.
c) Rotating Direction Switch (with Activation Lock)
The rotating direction switch (4) can be used to switch the rotating direction
between left and right.
A double arrow on the rotating direction switch (on the left (A) and right
(not illustrated) sides on the cordless screw driller) indicates the rotating
direction:
► ► Rotating direction to the left (viewed from the rear), to release/
turn out screws
◄ ◄ Rotating direction to the right (viewed from the rear), to fasten/
turn in screws or to drill holes
The rotating direction must be chosen depending on whether
holes are to be drilled or whether a screw is to be turned in or out.
In the middle position, the rotating direction switch will block the on/off switch
and thus the motor in the cordless screw driller.
At tool change, maintenance or cleaning, as well as during transport or storage, the on/off switch must be
blocked with the rotating direction switch (4) for reasons of safety. There is a danger of injury in case of
accidental actuation of the on/off switch!
Switch the rotating direction only when the drive of the cordless screw driller has stopped completely!
Otherwise, the drive may be damaged.
B
A
A
31