Setting Ring For Torque; Led - BASETech 1429464 Mode D'emploi Original

f) Setting Ring for Torque
Turning the torque setting ring (2) permits setting of the desired torque from
which onwards the slip clutch will engage. This will prevent over-turning, e.g.
when turning in a screw. The screw will end flush with the material surface
when the torque setting is chosen accordingly.
The torque setting has 17 different positions and an additional position for the
drilling function (drill symbol, ideal for drilling holes).
Low setting: Soft materials, small screws
High setting: Hard materials, large screws
Drill symbol: Slip clutch off
When turning out screws, a higher setting or the "drill" setting (drill
symbol) should be chosen.
g) LED
When the on/off switch (8) is pushed, the LED (9) will be activated automatically
to permit lighting of the working position.
A
B
33