Operation; Tool Attachment; Assembling The Flexible Shaft - BASETech 814677 Mode D'emploi

• When working, wear goggles, hearing protection as well as a dust mask. It is
recommended that you wear an apron as well as protective shoes where possible.
• Do not wear any jewelry when working.
• Tie up hair or loose clothing in the proper fashion so that they do not get caught
in rotating parts.

6. Operation

a) Tool Attachment
1. Choose the proper tool for the operation and the proper collet chuck.
2. Assemble the cutting disks, polishing disks and grinding attachments to their accompanying
holders.
3. Press in the latch button on the shaft end of the device to lock the shaft in place. Unscrew
the knurled nut, insert the proper collet chuck into the slot and gently screw the knurled nut
back on.
4. Insert the shaft of the selected tool into the collet chuck and tighten all parts using a match-
ing open-end wrench so that they do not slip.
The procedure when using the tool fitting on the flexible shaft is the same; however,
the shaft is locked in by inserting the stop key in the hole provided.
It is recommended that the device be disconnected from the power supply each time
you change the tool in order to avoid injuries resulting from accidentally activating the
ON/OFF switch.
b) Assembling the Flexible Shaft
1. Select a collet chuck custom-fit to receive the square end of the flexible shaft.
2. Press in the latch button on the shaft end of the device to lock the shaft in place for the
following operation.
3. Unscrew the knurled nut.
4. Remove the plastic lock bush on the shaft end of the device housing.
5. Gently pull out the flexible shaft from the covering and insert the collet chuck 3-5 cm on the
square end and push both into the slot.
6. Tighten the flexible shaft with the lock bush on the threading on the device casing.
7. Tools are installed in the tool attachment slot of the shaft as described above.
21