Slider For Two-Speed Gear; On/Off Switch With Rotating Speed Control - BASETech 1429464 Mode D'emploi Original

d) Slider for Two-Speed Gear
At the top of the cordless screw driller, there is a slider (3) for selection of the
two speeds of the integrated two-speed gear.
A 1st gear, low speed (0 - 350 rpm), high torque
B 2nd gear, high speed (0 - 1300 rpm), low torque
The slider for selection of the two gears must only be actuated
when the drive of the cordless screw driller has stopped complete-
ly! Otherwise, the drive may be damaged.
If one of the gears cannot be engaged when the slider is pushed,
the drive sprockets may be placed badly towards each other.
In this case, push the on/off switch slightly so that the sprockets
will move a little way. Then you should be able to use the slider.
e) On/Off Switch with Rotating Speed Control
In order to operate the on/off switch (8), the rotating direction
switch (4) must not be in the middle position (in this position, the
on/off switch is blocked!).
The rotating speed of the drive depends on how far the on/off switch (8) is
pushed in (B). This permits smooth adjustment of the speed from standstill
to maximum speed.
When releasing (A) the on/off switch, the drive will be braked to the stop
("rotating stop").
When the on/off switch (8) is pushed, the LED (9) will be activated
automatically to permit lighting of the working position.
At tool change, maintenance or cleaning, as well as during trans-
port or storage, the on/off switch must be blocked with the rotating
direction switch (4) for reasons of safety. There is a danger of inju-
ry in case of accidental actuation of the on/off switch!
32
B A
A B