Fulgor Milano QUAD QO 6009 PT Mode D'emploi page 19

Programming automatic cooking
Cooking function with set times.
Press the central button for 3 seconds. Then press it
again until "dur" appears. Press "+" and "-" to set the
required cooking time. Wait a few seconds for the setting
to be memorised.
Press the central button for 3 seconds. Press it another
two times and wait for "End" to appear (figure 4). Press
"+" and "-" to set the required end of cooking time.
E.g.:
Current time: 12.30
Cooking time: 10 minutes
End of cooking time: 14.00
The oven will start cooking at 13.50 (14.00 less 00.10)
at the set temperature and in the set mode and will stop
at 14.00.
The oven will beep when it stops cooking. To disable it,
press any button.
Adjusting beep volume
To adjust beep volume, press "+" and "-" together. Then
press the central button and wait for "ton1" (high volume)
to flash. Press "-" to select "ton2" (medium volume) or
"ton3" (low volume).
Press the central button to set the selected volume.
Replacing the oven light
IMPORTANT:
The oven light must have these precise features: a) it
must be able to resist high temperatures (up to 300°C)
b) power supply: see V/Hz indicated on data plate.
c) power 25W.
d) E 14 connection. Before proceeding, disconnect
the appliance from the main electricity supply.
- To prevent damage, place a tea cloth in the oven;
- unscrew the glass cover of the light;
- unscrew the old light bulb and replace it with the new
one;
Fig. 5
- put back the glass cover and remove the tea cloth;
- connect the appliance to the main electricity supply;
Fig. 6
19
GB