3M Accuspray PN 26580 Guide D'utilisation page 12

Vertical Pattern
Horizontal Pattern
Note: The spray pattern can also be changed from vertical
to horizontal by rotating the air cap a 1/4 turn.
Do not point the spray gun up while cleaning it.
Do not immerse the spray gun in solvent.
Note: Do Not Put In Gun Washer. Read, understand and follow all safety statements as well as wear
appropriate, approved personal protective equipment per the applicable SDS and material container labels for
cleaning solutions.
Periodically, lubricate moving components such as the fl uid needle, fan adjustment threads, fl uid needle adjustment threads
and spring.
ATTENTION
Note: Do Not Put In Gun Washer.
Solvent left in the spray gun air passages could result in a
poor quality paint fi nish. Do not use any cleaning method
which may allow solvent into the spray gun air passages.
Do not expose air fl ow control valve and gauges to
solvent as damage may occur.
Cleaning Process
1. Relieve the air and fl uid pressure from the spray gun and cup before servicing.
2. To retain unused paint or temporarily store mixed material, see your Local, State, Federal and OSHA guidelines, along
with paint manufacturer's recommendations for storage.
3. To fl ush spray gun, run water or compatible and compliant solvent into the spray gun fl uid passage while triggering
the spray gun until the cleaning fl uid appears clear.
Note: If feasible, clean atomizing head prior to disposal. Dispose of all used atomizing heads and spray gun bodies in
accordance with federal, state and local regulations. To change the atomizing head, refer to the section "Attaching the
Atomizing Head" on page 7.
Do not wipe the spray gun with a cloth soaked in solvent;
wring out the excess.
Do not use metal tools to clean the air cap holes as this may
scratch them; scratches can distort the spray pattern.
10