Ibanez TROUBADOUR T10 Mode D'emploi page 10

Warning
This headphone output produces a large volume of sound. Ensure that the
volume has been turned down before beginning to play using the headphones,
and then slowly increase the volume until it has reached the desired level. Note
that the noise and distorted sound signals produced when inserting or remov-
ing the headphone plug at high volume levels will result in damage to the head-
phones and to the user's hearing.
8
All manuals and user guides at all-guides.com
Troubleshooting
1. The power supply cannot be switched ON.
• Check that the power cable has been connected correctly.
• Try plugging it into a different power supply socket and see if the same prob-
lem occurs.
2. The power supply can be turned ON, but no sound is
produced.
• Check to see if the volume on the amp is set to "0".
• Check that the guitar has been connected correctly.
• Check to see if the volume on the guitar is set to "0".
• Replace the shielded guitar cable and check to see if no sound is produced.
• Check to see if there are batteries in the guitar. If there are, check that they are
OK.
• Remove any effects that may be connected between the guitar and the ampli-
fier and check to see if no sound is produced.
• Use a different guitar and see if no sound is produced.
3. Noise occurs
• Check to see if anything in the immediate vicinity is resonating or banging
against the amplifier to produce the noise.
• Check to see if the plug cover on the shielded guitar cable is loose.
• Check that the string action (distance between strings and frets) is correctly
adjusted (not too low).
• Check to see if the guitar batteries are depleted.
• Use another guitar, effects and cable to see if the same noise is produced.
In the case of defects
This product has passed exhaustive inspections before being shipped from the
factory. Ensure that the above procedures are carried out when a problem is
thought to exist. Contact your dealer in the unlikely event that an abnormality
occurs during use. Also, ensure that the symptoms of the problem are explained
in detail when requesting repairs in order to facilitate swift handling.