Med-Fit 1 Manuel D'instructions page 13

Chapter 9 : PREPARATION FOR USE
It is recommended that for persons with sensitive skin, the area is
prepared prior to the application of the self adhesive electrodes by
cleaning using soap and water or alcohol wipes and then drying
thoroughly. It is quite normal to see a reddening of the skin under-
neath the electrodes following treatment but this usually disappears
in less than 2 hours.
If the reddening persists we recommend PALS (BLUE) electrodes
Chapter 10 : APPLICATION OF RE-USABLE SELF
Application
1. Clean and dry the skin at the thoroughly with soap and water prior
to application of electrodes.
2. Insert the lead wire into the pin connector on the pre-wired
electrodes.
3. Remove the electrodes from the protective liner and apply the
Removal
1. Peel the electrodes from the skin; do not pull on the lead wires
because it may damage the electrodes.
2. Place the electrodes on the liner and remove the lead wire by
gently twisting and pulling.
Care and Storage
1. Between uses, store the electrodes on their liner in the resealable
bag in a cool dry place.
2. The adhesive properties of the electrodes may be improved by
applying a few drops of cold water and allowing the electrode
surface to dry. Do NOT soak the electrodes.
ADHESIVE ELECTRODES
10
10