AEG Solo Combo 15 Guide Rapide page 5

5.2 Installing the cordless handset and charging the batteries (see P5)
Insert the 2 supplied batteries into the battery compartment of the cordless handset, observing the
correct polarity (see markings inside battery compartment).
Warning:
Use only the supplied NiMH rechargeable batteries.
Place the back cover over the back of the cordless handset and press down until it clicks into place.
Place the cordless handset on the charging pod and charge for 15 hours before using the cordless
handset for the first time.
The cordless handset will give a double beep when it is properly placed on the charging pod.
The battery charging indicator on the charging pod lights up to indicate charging.
Note:
The cordless handset may become warm when the batteries are being charged or during prolonged
periods of use. This is normal and does not indicate a fault.
6 GETTING TO KNOW YOUR PHONE
6.1 Cordless handset overview (see P1)
# Icon
In standby mode, press to enter the Main Menu list.
1
Press to select an item, or to save an entry or setting.
In menu mode, press to scroll up.
2 During a call or message playback, press to increase the volume.
In standby mode, press to access the call log.
Press to make or answer a call.
3 During a call or message playback, press to switch between speakerphone and
earpiece.
Press and hold to switch the key lock on or off.
4
During a call, press to send a Flash signal for network services.
5
In standby mode, press to access the redial list.
6
In standby mode or during a call, press to initiate an intercom call or transfer a call.
7
Press to cancel an action.
During pre-dialling, press to delete the last digit entered.
8
During a call, press to mute the microphone, and press again to resume
conversation.
Meaning
3