Publicité
Les langues disponibles
Les langues disponibles
10
8.10
Initiate an Intercom Call to the Corded Base
In standby mode, press
>Intercom with the corded base is established immediately if there is only one registered cordless
handset.
>If there are more registered cordless handsets, the handset numbers which are available for
intercom will be displayed. Press 0 to call the corded base.
Press
or pick up the corded handset from the corded base to answer the internal call, where both
internal callers can talk.
To end the intercom call, press
base.
Note:
If there is no answer from the corded base, or you wish to cancel the intercom call before it is answered,
press
to return to the external call.
9
USING YOUR CORDED BASE
9.1
Make a call
9.1.1
Pre-dialling
In standby mode, enter the phone number (maximum 24 digits).
If you make a mistake, press
Pick up the corded handset from the base unit or press to dial the number.
When you complete the call, return the handset to the corded base unit or press .
9.1.2
Direct dialling
Pick up the corded handset from the base unit or press .
Listen for the dial tone and then enter the phone number.
When you complete the call, return the handset to the corded base unit or press .
9.2
Adjust Earpiece or Speaker Volume
There are 5 volume levels.
During a call, press + or - to select from L1 to L5.
>The current setting is shown.
>When you end the call, the setting will remain at the last selected level.
9.3
Set Ringer Volume
You can set the ringer volume on the corded base from L0 (ringer off) to L5.
In standby mode, press + or - to select the desired setting (each volume level will play as it is select).
Note:
The corded base will ring at the selected volume level when it receives an incoming call.
If you set ringer volume to L0,
receives an incoming call.
.
on the corded base or return the corded handset to the cordless
to delete the last digit entered.
will appear on the LCD and the corded base will not ring when it
Publicité
