Samsung HW-H7500 Manuel D'utilisation page 14

CONNECTIONS
CONNECTIONS
CONNECTING THE WIRELESS SUBWOOFER
The Subwoofer's linking ID is preset at the factory and the main unit and subwoofer should link (connect wirelessly)
automatically when the main unit and subwoofer are turned on. If the Link indicator (
unit and subwoofer are turned on, please set the ID by following the procedure below.
I D S E T
1. Plug the power cords of the main unit and subwoofer
into an AC wall outlet.
2. Press the ID SET button on the back of the
subwoofer with a small, pointed object for
5 seconds.
•
The STANDBY indicator is turned off and the
LINK indicator (Blue LED) blinks quickly.
3. While the main unit is powered off (in STANDBY
mode), press and hold the
control for 5 seconds.
4. The ID SET message appears on the Soundbar's
display.
5. To finalize the link, turn the main unit's power on while
the subwoofer's Blue LED blinks.
•
The main unit and the subwoofer should now be
linked (connected).
•
The Link indicator (Blue LED) on the subwoofer
should be on.
•
If the Link indicator is not solid blue, the linking
process has failed. Turn off the main unit and
start again from Step 2.
•
You can enjoy better sound from the wireless
subwoofer by selecting a Sound Effect.
(See page 10)
● Before moving or installing the product, be
sure to turn off the power and disconnect the
power cord.
All manuals and user guides at all-guides.com
I D S E T
(Mute) on the remote
14
) does not light when the main
● If the main unit is powered off, the wireless
subwoofer will be in standby mode and the
STANDBY LED on the upper side will come
on after the Link indicator (Blue LED) blinks
for 30 seconds.
● If you use a device that uses the same
frequency (2.4GHz) as the Soundbar near the
Soundbar, interference may cause some
sound interruption.
● The transmission distance of the wireless
signal between the main unit and subwoofer
is about 33 ft, but may vary depending on
your operating environment. If a steel-
concrete or metallic wall is between the main
unit and the wireless subwoofer, the system
may not operate at all, because the wireless
signal cannot penetrate metal.
● If the main unit doesn't make a wireless
connection, follow steps 1-5 in the left hand
column to re-set the connection between the
main unit and wireless subwoofer.
● The wireless receiving antenna is built into the
wireless subwoofer. Keep the unit away from
water and moisture.
● For optimal listening performance, make sure
that the area around the wireless subwoofer
location is clear of any obstructions.