Publicité
Les langues disponibles
Les langues disponibles
6
All manuals and user guides at all-guides.com
A Shaver
Your Braun Flex Integral is supplied with a Braun
Clean&Charge (please see section B).
Technical specifications
• Wattage via cord set: 7 W
• Automatic power supply: (100-240 V~/ 50 or 60 Hz)
• Shaver input voltage: 12 V
Description
1 Foil protection cap
2 Shaver foil
3 Cutter block
4 Foil release button
5 Pop-out long hair trimmer
6 Switch lock
7 Switch for locking the pivoting head («head lock»)
and for activating the pop-out long hair trimmer
(«trimmer»)
8 On/off switch
9 Charging light
10 Shaver socket
11 Power supply cord set
Charging the shaver
• First charging: Using the power supply cord set,
connect the shaver to the mains with the switch
on position «off» and charge it for at least 4 hours
(plug might get warm).
• Once the shaver is completely charged, shave with-
out the cord until fully discharged. Then recharge to
full capacity again (subsequent charges will take
about 1 hour).
• A full charge will give up to 50 minutes of cordless
shaving time depending on your beard growth.
However, the maximum battery capacity will only be
reached after several charging/discharging cycles.
• Best environmental temperature range for charging
is 60 °F to 95 °F / 15 °C to 35 °C.
• The charging light shows that the shaver is being
charged. When the rechargeable batteries are fully
charged, the charging light goes off.
If later on, the charging light comes on again, this
indicates that the shaver is being recharged to
maintain its full capacity.
Publicité
