EIBENSTOCK ERS 180 Notice Originale page 18

Tool Change
Attention!
Before the beginning of all works disconnect the plug from
the mains!
Only use original accessories in order to allow an optimal extraction.
Changing the rubber foam pad and the base plate:
Rubber foam pad:
Base plate:
2
Attention!
Before you start working, check whether the accessory has the exact
position. Let the machine start running in a safe position for a short
time. In case the machine does not run easily, immediately stop
working.
The additional handle included in delivery can be mounted right or left
depending on working method.
Put the sanding paper in that way on the
Velcro-type fastening disc of the machine,
that the extraction holes will not be hidden.
The seven-time punch hole of both parts as
well as the centering pin supplied along with
as a mounting help allow an easy positioning
of the grinding paper on the machine.
Remove the sanding paper if existing.
Loosen the Velcro-type fastening disc
by means of the enclosed socket wrench
(1).
To counter hold put the jaw wrench (2)
through the opening in the protective hood
1
on the workspindle.
18