BorMann PRO BBC2030 Mode D'emploi page 6

EN EN
ERROR SITUATIONS
Digital display Warning LED indicator
E04 WARNING
LED lit
BATT - MISMATCH WARNING
LED lit
Connecting to the battery
1) Identify polarity of battery posts. The positive battery terminal is typically marked by these letters or symbol (POS, P, +). The negative battery terminal is
typically marked by these letters or symbol (NEG, N, –).
2) Do not make any connections to the carburetor, fuel lines, or thin metal parts.
3) Identify if you have a negative or positive grounded vehicle. This can be done by identifying which battery post (NEG or POS) is connected to the chassis.
4) For a negative grounded vehicle (most common): connect the RED POSITIVE clamp first to the positive battery terminal, then connect the BLACK NEGATIVE
clamp to the negative battery terminal or vehicle chassis.
5) For a positive grounded vehicle (very uncommon): connect the BLACK NEGATIVE clamp first to the negative battery terminal, then connect the RED POSITIVE
clamp to the positive battery terminal or vehicle chassis.
6) When disconnecting, disconnect in the reverse sequence, removing the negative first (or positive first for positive ground systems).
7) A marine (boat) battery must be removed and charged on shore. To charge it on board requires equipment specially designed for marine use.
OPERATING STEPS
Step no. Determine whether or not to connect
Step1 Ensure battery connection
Step2 Ensure battery type
Confirm battery type
Step3 Ensure charging mode
Confirm FUNCTION
Confirm Ensure start charging
ENGINE START
Note: When the digital tube is only displayed as OFF, the charger can choose the corresponding mode, in FUNCTION SELECTION.
6
Meaning
No battery connected / battery voltage is
lower than 1 volt (dead battery) / red and
black clamps are connected together.
Charging in 12V
Mode for 24V battery
Step select key
Digital display: Connected battery voltage
Corresponding battery type LED:
Corresponding Function LED:
WWW.NIKOLAOUTOOLS.GR
SOLUTION
1) Connect the red and black clamps or ring
terminals to battery posts
2) Clean the battery posts
3) Replace the battery with a new one
immediately
4) Disconnect red and black output terminals
Replace the battery or connect the positive out-
put line to the correct connector .
NORMAL-5A-Digital display: "CHARGING"
NORMAL-10A-Digital display: "CHARGING"
BOOST-20A-Digital display: "CHARGING"
12V-REPAIR-Digital display: "REPAIR-ON"
Corresponding Function LED:
ENGINE START-Digital display: "START-
READY"