BorMann PRO BBC2030 Mode D'emploi page 4

EN EN
TECHNICAL DATA
Model: BBC2030
Input: 230 V AC, 50/60 Hz,1500 W MAX
Output: 12/24 V DC, 5/10/20 A
Starting current: 80 A 100 A (1V)
Battery capacity: 350 AH, All type of 12 / 24 V lead-acid batteries (WET/MF/CA/
EFB/GEL/AGM)
Lowest Chargeable 3V
Voltage:
Additional - Alternator check function
specifications: - Independent STD/GEL/AGM battery type selection
- Digital display
- Detailed error messages on screen
- Charging functions: 10 steps, Fully-automatic Charging Cycle
- Housing protection: IP20
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes significantly affect the
performance and safety of the products. The parts described / illustrated in the pages of the manual that you hold in your hands may also concern other models of the
manufacturer's product line with similar features and may not be included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and special
adjustments, must only be carried out by technicians of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided equipment may cause malfunctions or even serious injury or death. The
manufacturer and the importer shall not be liable for injuries and damages resulting from the use of non-conforming equipment.
OPERATING INSTRUCTIONS
Display messages
Start up – After display screen and all LEDs illuminate for 0.5 second, battery voltage shows (meanwhile battery VOLTAGE LED is lit).
DISPLAY BUTTON
Digital display
Battery-voltage
Battery - %
Alternator - %
4
LED indicator
Voltage LED lit
Battery % LED lit
Alternator % LED lit
WWW.NIKOLAOUTOOLS.GR
Description
When the charger is NOT working in ENGINE
START, the display will show the battery
VOLTAGE.
When the charger is NOT working in ENGINE
START, the digital display shows percentage of
the battery connected to the charger's battery
clamps.
The digital display shows an estimated output
percentage of the vehicle's charging system
connected to the charger's battery clamps,
compared to a properly functioning system. The
alternator percent range is from 0% to 100%.
Readings below 0% (13.4 volts/26.8 volts) will
read LO and readings above 100% (14.4
volts/28.8 volts) will read HI. If you get a HI or
LO reading, have the electrical system checked
by a qualified technician.