Télécharger Imprimer la page

Saunum AirSolo Instructions D'utilisation Et D'installation page 15

Régulateur de sauna

Publicité

Les langues disponibles

Les langues disponibles

steam room and the bench and floor may
become too hot.
To ensure long service life of the Device,
make sure that the temperature in the
steam room at the lower part of the
Device does not exceed 176 °F. If this
temperature is exceeded, the thermal pro­
tection will activate and the fan will stop;
once the temperature falls below the acti­
vation level of the protection, the fan will
be switched on again.
The manufacturer will not be held liable for
equipment failures resulting from exceed­
ing the permitted operating temperature.
If your Device is equipped with internal
lights, the lights will activate at the same
time as the fan (see the marking on the
packaging of the Device) when the Device
is switched on.
If your Device is wall­integrated and
equipped with an external touch­
sensitive switch for speed control,
please keep in mind the following
requirements:
• The external speed switch may
only be installed outside the steam
and washing room, e.g. the chang­
ing room, preferably next to the
door, so that the Device can be
conveniently switch on and off.
• The switch has three positions for
selecting the desired airflow inten­
sity. The Device can be switched on
and off by pressing and holding
the touch­sensitive button of the
desired speed.
• Touch the appropriate area to
select speeds.
• If the Device is equipped with
internal lighting, a separate switch
(optional) must be used to switch
it on.
INSTRUCTIONS FOR USING
HIMALAYAN SALT BALLS
The sauna climate unit comes with Hima­
layan salt balls. The use of salt balls in the
Device is optional and does not affect the
basic function of the Device.
To use the salt balls, they must be placed in
the base tray located between the air dis­
charge grille and the fan. Make sure that
the salt balls are placed correctly and do
not impede the rotation of the fan.
To place or remove the salt balls (see
Figures 1D and 2C), loosen the two fasten­
ing bolts on the discharge grille and lower
the grille on its hinges. Do not use excessive
force! After placing or removing the salt
balls, shut the discharge grille and fasten it
with two bolts.
The sauna climate unit may only be used
if the grille is installed!
15

Publicité

loading