IKEA MUTEBO Mode D'emploi page 13

ENGLISH
First connection
The display shows welcome message after the first connection.
You have to set: Language, Display brightness, Key tones, Buzzer volume, Water hardness,
Time of day.
Initial preheating
Step 1 Remove all accessories and removable shelf supports from the oven.
Step 2
Set the maximum temperature for the function:
Let the oven operate for 1 h.
Step 3
Set the maximum temperature for the function:
Let the oven operate for 15 min.
The oven can emit an odour and smoke during preheating. Make sure that the room is
ventilated.
How to set: Water hardness
When you connect the oven to the mains you have to set the water hardness level.
Use the test paper supplied with the steam set.
Step 1
Put the test paper
into water for about
1 sec. Do not put the
test paper under
running water.
The colours of the test paper continue to change. Do not check water hardness later
than 1 min after test.
You can change the water hardness level in the menu: Settings / Setup / Water hardness.
The table shows water hardness range (dH) with the corresponding level of Calcium deposit
and the water classification. Adjust the water hardness level according to the table.
Preheat the empty oven before the first use.
Step 2
Shake the test paper
to remove the excess
of water.
.
.
Step 3
After 1 min, check
water hardness with
the table below.
Step 4
Set the water hardness
level: Menu / Settings /
Setup / Water hard‐
ness.
13