Uline h-9790 Mode D'emploi page 2

NOTE: Assemble on smooth, non-marring
surface to avoid scratching.
NOTE: Use Allen wrench to tighten bolts.
NOTE: Use Phillips screwdriver to tighten screws.
NOTE: Check that all parts are included.
1. Install floor glides (E) on leg frames (2). (See Figure 1)
Figure 1
2
E
2. Align support bar (3) with holes on leg frames (2)
and secure using three M6 x 20 mm bolts (C) on
each side. (See Figure 2)
Figure 2
2
PAGE 2 OF 18
3
C
ASSEMBLY
3. Attach four desktop brackets (A) to leg frames (2)
using two M6 x 20 mm bolts (C) per bracket.
(See Figure 3)
Figure 3
2
To continue desk assembly, proceed to step 4.
To continue L-desk assembly, proceed to L-Desk
Return Assembly on page 4.
4. Place desktop panel (1) upside down with holes
facing up. With second person, turn assembled
desk frame upside down. Use four M6 x 15 mm
screws (D) to secure each desktop bracket (A) to
desktop panel. (See Figure 4)
Figure 4
2
C
A
D
A
1
0922 IH-9790