Berker 7574 01 01 Mode D'emploi page 39

(16) Dismantling opening
5.2 Commissioning
system link – Loading the physical address and application software
The device is connected to the KNX bus and auxiliary voltage.
The physical address is only ever assigned for one device. Only one de-
vice can ever be in programming mode.
„ Switch on bus voltage
„ Switch on auxiliary voltage.
„ Press programming button
The programming LED
Or via the menu:
„ Press control surface
Mo. 30.06.14 07:22
The display changes to the menu
„ Then select
„ Switch control surface for
The device is in programming mode.
„ Load the physical address into the device.
The programming LED goes out. In the display, the message
automatically.
Seite 5 Seite 6
„ Load application software into the device.
„ Stick enclosed stickers on the back of the device and note down the phys-
ical address.
All manuals and user guides at all-guides.com
(16)
(11)
Figure 12: Dismantling
in the top display row (8).
-
Seite 7
(5) at the back of the device.
(5) lights up.
.
- in succession.
–
ON
appears briefly. The device is restarted
.
z
39