Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
The installations described below should be made by
qualified service personnel or system installers.
Mounting in the Rack
1. Remove the four rubber feet by removing the four
screws on the bottom of the camera drive unit.
2. Place the rack mounting brackets on both sides of the
camera drive unit and tighten the six supplied screws
(M3x10).
Fix the rack mounting brackets
5
All manuals and user guides at all-guides.com
Remove 4 rubber feet
Six screws (Supplied)
3. Install the camera drive unit with the rack mounting
brackets on the rack using four screws (not supplied).
Cautions:
• Do not block the ventilation opening or slots in the
cover to prevent the appliance from overheating.
• Always keep the inside rack temperature below
45°C (113° F).
• The cooling fan inside the camera drive unit is sub-
ject to wear and need to be replaced periodically.
• Secure the rear of the appliance to the rack by
using additional mounting brackets (procured
locally) if the rack is subject to vibrations.
Publicité
