Depressed Center Wheel Assembly And Disassembly - Metabo HPT G 18SE3 Instructions De Sécurité Et Mode D'emploi

English
DEPRESSED CENTER WHEEL ASSEMBLY
AND DISASSEMBLY
WARNING
Never attempt to assemble or disassemble
the depressed center wheel, unless the power
switch is in the "OFF" position and the electrical
cord has been disconnected from the receptacle.
1. Assembly
(1) Turn the disc grinder upsidedown so that the
spindle is facing upward.
(2) Align the oval-shaped indentation of the wheel
washer with the notched part of the spindle, then
attach them.
(3) Fit the protuberance of the depressed center
wheel onto the wheel washer.
(4) Screw the wheel nut onto the spindle.
(5) While pushing the push button with one hand, lock
the spindle by turning the depressed center wheel
slowly with the other hand.
Tighten the wheel nut by using the supplied
wrench as shown in Fig. 5.
Wrench
Wheel Nut
Depressed
Center
Wheel
Wheel Washer
Wheel Guard
Spindle
CAUTION
Tighten the wheel nut securely and confi rm that
the depressed center wheel does not wobble.
2. Disassembly
To remove the depressed center wheel, simply
reverse the above-mentioned procedure.
12
Tighten
Push Button
Fig. 5