Hot-Air Hair Curler - SEVERIN WL-809 Mode D'emploi

GB

Hot-air hair curler

Dear Customer,
Before using the appliance, please read the
following instructions carefully and keep this
manual for future reference. The appliance
must only be used by persons familiar with
these instructions.
Connection to the mains supply
The appliance should only be connected to
an earthed socket installed in accordance
with the regulations.
Make sure that the supply voltage
corresponds with the voltage marked on the
rating label of the appliance.
This product complies with the directives
which are binding for the CE-labelling.
Familiarisation
1. End cap
2. Round brush (Ø 25 mm) with soft
bristles and air outlet openings
3. Curl release button
4. 3-position switch
5. Housing
6. Air inlet openings
7. Power cord with swivel
8. Round brush (Ø 20 mm) with hard
bristles
Important safety instructions
∙ Caution! Do not use the
appliance in the vicinity
of a bath, shower or
swimming-pool, over a washbasin
fi lled with water or any other
8
receptacle containing water.
∙ There is always a risk when the
appliance is operated near water
even when it is switched off.
Therefore, if the appliance is being
used in a bathroom always remove
the plug from the wall socket after
use.
∙ Additional protection is offered
by fi tting an earth-leakage circuit-
breaker with a rated tripping current
not exceeding 30mA into your
bathroom installation. Please consult
a qualifi ed electrician.
∙ In order to avoid hazards, repairs
to this electrical appliance or its
power cord must be carried out by
our customer service. If repairs are
needed, please send the appliance
to our customer service department
(see appendix).
∙ To avoid the risk of electric shock, do
not clean the appliance with water
and do not immerse it in water.
∙ Before cleaning the appliance,
ensure it is disconnected from the
power supply and has cooled down
completely.