English
Batteries
This appliance operates on two 1.5 volt
batteries. For best performance, use alkaline
batteries (type LR 6, AM 3, MN 1500 or size AA
alkaline, e.g. Duracell). These batteries provide
a shaving capacity of approx. 60 minutes.
8
Slide the battery
cover in the direction
indicated by the arrow, then open. Insert
7
batteries
with the poles in the direction
marked. Close the battery cover and slide it
back to start position.
Note: Never leave batteries in the shaver for
long periods of time when the shaver is not in
use (danger of leakage). Take expired batteries
out of the shaver immediately.
Used batteries should not be thrown away with
the house hold waste. Please dispose of them
at special collection points or return them to
your retailer or authorized service centre.
Shaving
Turn the twisting protective cap
clicks in place as shown (b). This will extend
your shaver for better handling and allow
operation of the on /off switch.
To switch the shaver on, push the on /off switch
2
upward to the « on » position.
Hold the shaver at right angles to your skin (c)
and shave against the direction of beard
growth.
Tip: Stretch the skin slightly and only apply
gentle pressure.
Cleaning and maintenance
To experience the best possible shave you
should clean the shaver after each use:
1. Press foil frame release buttons
remove the foil frame
2. Tap the foil frame gently against a flat
surface, then clean the cutterblock
thoroughly with the brush
3. Place the foil frame over the cutterblock and
gently push down until it clicks back into
position.
Approximately every four weeks clean the
3
cutterblock
with Braun cleaning products.
After cleaning, turn the twisting protective cap
1
180° to cover the shaving head. In this
position, the on/off switch is automatically
locked to avoid accidental operation of the
shaver (e. g. when travelling).
1
(a) until it
5
and
4
(e).
3
6
as shown (f ).