Oase biOrb Notice D'emploi page 21

How to proceed:
• When the unit has been operating for about
one day, check the water temperature with
the supplied thermometer.
• The measured temperature is lower than the
set temperature: Check the water flow
around the unit and, if necessary, move the
unit to a different position where the water
circulation is not obstructed by e.g. plants
• Measure the temperature again after some
time.
• The temperature difference is still too great:
Set a slightly higher temperature on the unit.
• Measure the temperature again after some
time.
• Change the setting again if necessary.
• The measured temperature is higher than
the set temperature: Set a slightly lower tem-
perature on the unit.
• Measure the temperature again after some
time.
• Change the setting again if necessary.
CLEANING
If necessary, clean the unit with clear water using
a soft sponge or cloth.
• Do not not use cleaning agents or chemical
solutions.
WEAR PARTS
• Suction cup
DISPOSAL
N O T E
Do not dispose of this unit with domestic waste.
• Render the unit unusable beforehand by cut-
ting the cables and dispose of the unit via the
return system provided for this purpose.
- EN -
21