KitchenAid KSMSIA Manuel Du Propriétaire page 4

3.
Remove the molds from the freezer and allow ice to rest, in the mold, for up to 10 minutes
this is called "Tempering" and is recommended to achieve ideal Shave Ice results.
Alternative Steps: Remove the lid, turn the ice mold on its side and run it under lukewarm
water for 15 – 20 seconds, rotating the mold to wet all sides. Turn the mold upside down
and press firmly on the mold upside down and press firmly on the bottom/sides of the mold
to extract the puck.
NOTE: If you follow Alternative Steps above, the recommended tempering time may be
greatly reduced. Your ice is properly tempered when a wet, glossy sheen covers the entire
surface. This can take up to 10 minutes under some circumstances.
NOTE: See "Tips for Great Results" sections in Online "Product Guide" for more details on
Ice Puck Preparation.
SET UP AND ASSEMBLY - PREPARING TO MAKE SHAVE ICE
Before using your Shave Ice Attachment, clean it by following the detailed instructions in "Care
and Cleaning" section.
1.
Turn the Stand Mixer off (Off/0) and then unplug.
2.
For Stand Mixer with a hinged attachment hub cover: Flip up to open.
For Stand Mixer with a removable attachment hub cover: Turn the attachment knob
counterclockwise to remove the attachment hub cover.
3.
Insert the Main Housing into the attachment hub, make sure the power shaft fits into the
square hub socket. If necessary, rotate the attachment back and forth for proper fitment.
The pin on the attachment housing will fit into the notch of the hub rim when in the proper
position.
4.
Tighten the Stand Mixer attachment hub knob clockwise until the attachment is completely
secured into the Stand Mixer.
5.
Ensure that the upper lever of the housing is rotated all the way to left. If not, rotate it to the
left until it clicks into place. This will ready the attachment for use and must be completed
before loading the Ice Puck into the Ice Cup and attaching it to the housing.
6.
Remove the Ice Cup from the housing by rotating it to the right and pulling downward. Take
note of the small indicator arrow which must line up with the Lock and Unlock symbols on
the housing.
OPTIONAL: If you wish to change the blade, grip the blade from the bottom and rotate it to
right to unlock and remove.
ASSEMBLY
1.
Grip the blade from the bottom and slowly insert it into the bottom of the Ice Cup by
aligning the interlocking tabs. Once inserted, rotate the blade to the left until you hear a
"Click", to properly lock the blade in place.
NOTE: Each of the interlocking tabs is unique size, ensuring the blade can only be
installed in the correct position.
2.
Insert the Ice Cup Sleeve into the Detachable Ice Cup, then insert a prepared Ice Puck. Be
sure to insert the ice puck with the cross hatches facing upward.
3.
Attach the Detachable Ice Cup to the bottom side of the Main Housing, rotating it to the left
to lock it in place.
NOTE: The small indicator arrow on the Detachable Ice Cup that should line up with the
Lock and Unlock symbols on the Main Housing.
4.
Release the top lever by gently rotating it to the right. The spring will engage as the Ice
Pusher clamps down on the ice puck. The Shave Ice Attachment is properly loaded and
ready to use.
4