Chicco NaturallyMe Mode D'emploi page 23

Problem
The breast pump does not pump or
pumps very little.
Milk expression is painful.
The breast pump does not switch on
If none of the above operations solves the problem, contact Artsana S.p.A.
TECHNICAL SPECIFICATIONS
- Ref. 00 009199 000 000 ELECTRIC BREAST PUMP Mod. 06836
- Maximum vacuum level in extraction mode: -0.35 ± 0.03 bar**
(** Values measured with sample cylinder. CI 95%)
- Appliance service life: 500 hours
- Accessory service life: 2 years
- Service life in storage conditions: 4 years
- Minimum operating time with batteries: 75 minutes
- Noise level: less than 50 dBA at a distance of 1 m
- Type of appliance: intermittent operation; 30 minutes ON - 30 minutes OFF
- Motor body weight: 325 g excluding batteries
- Dimensions: 98x70xh105 mm
- Made in China
Storage, preservation and transportation conditions:
- Ambient temperature: -20 / +60°C
- Relative humidity: 10 to 85%
- Pressure: 700 to 1060 hPa
Operating conditions:
- Operating temperature: +5°C / +40°C
Cause
Valve not assembled or not properly
assembled.
Cup and motor body not assembly
correctly.
The cup does not fit well on the breast
Suction level not correctly adjusted.
Run-down and/or insufficiently
charged batteries.
Suction level too high.
Failure of mains adapter and/or
appliance.
Incorrect connections.
Run-down batteries.
23
Solution
Assemble the valve correctly.
Check that you have performed
the procedure described in the
"PREPARATION" paragraph correctly.
Make sure that the silicone tube is
firmly connected to both the motor
unit and the membrane cover.
Check that the tube is not damaged.
Do not twist the tube during milk
expression.
Fit the pump body over your breast,
taking care that your nipple is
properly centred. Try with/without
the soft silicone cover.
Change the suction level until
you achieve more comfortable
stimulation and suction by pressing
the "+" or "-" buttons.
Replace the batteries.
Change the suction level until
you achieve more comfortable
stimulation and suction by pressing
the "-" button.
Check that mains power is present.
Check the position of the batteries in
the battery compartment.
Check all the connections.
Replace the batteries.