Chicco NaturallyMe Mode D'emploi page 22

eration of the appliance, take care not to cover the hole on
the left-hand side of the pump body (4) with your hand.
Note: when switched on, the breast pump always starts
in stimulation mode to facilitate milk extraction, using the
factory settings (level 5). The stimulation indicator (23) will
appear on the display.
• After approximately 2 minutes of stimulation, the appli-
ance automatically switches to the extraction mode using
the factory settings (level 5). The extraction indicator (24)
will appear on the display.
• You can stop the stimulation stage and switch to the ex-
pression stage by briefly pressing the on/off button.
• If necessary, repeat stimulation by pressing the stimula-
tion/extraction button (16) again. Press the stimulation/
extraction button (16) to return to extraction.
• You can use the "+" (15) and "-" (14) buttons on the keypad
to adjust extraction/stimulation based on the level of pull
perceived on your breast and/or based on the amount of
milk expressed. We recommend adjusting the extraction/
stimulation rate gradually until you reach the level best
suited to you.
• If the level of extraction/stimulation chosen causes dis-
comfort or pain, suitable reduce it by pressing the "-" but-
ton (14).
• You can alternate milk extraction from both breasts.
• Press the on/off button (13) to switch the breast pump off.
• To avoid all danger deriving from spilt liquid (milk), we rec-
ommend that you never fill the feeding bottle beyond the
highest level indicated on its graduated scale.
• WARNING: immediately after each single use, carefully
clean all the components* as shown in the "CLEANING"
paragraph.
• To feed the milk immediately to your baby, unscrew the
feeding bottle from the pump body (4) to remove it.
Screw the ring with the teat (7) (included in the pack)
onto the feeding bottle. This way, you will obtain a handy,
ready-to-use baby feeding bottle.
• If, on the contrary, you close the bottle with the airtight
cap (8) (included in the package) you can store the ex-
pressed milk in the fridge for up to 48 hours at 4°C or for
up to 3 months at -18°C in the freezer.
• WARNING: When the breast pump is not used, always dis-
connect the mains adaptor from the mains.
*Excluding the motor body (10) and mains adaptor (18) and
the silicone tube (17).
CLEANING
• Before carrying out any cleaning operation, disconnect,
if connected, the mains adaptor from the mains and the
power cord connector from the socket (19) on the motor
body.
• Separate all the components from the breast pump.
Note: remove the valve (5), located on the circular duct in-
side the base of the pump body (4) by gently pulling the
tab on the side of the valve.
• WARNING: always remove the valve gently and do not
use any tool to clean it since this may damage it,making
the breast pump impossible to use.
Note: to remove the silicone tube, first detach the mem-
brane (1) and the membrane cover from the pump body,
to avoid any spillage. Then, holding the end inserted into
the membrane cover, gently pull it off.
• Carefully wash all the components* using hot water and
washing up liquid, thoroughly rinse and dry carefully using
a soft and clean cloth.
• Do not use abrasive products to clean the breast pump
and its components.
• Clean the motor body and the mains adaptor with a soft,
clean and dry cloth. Warning! Do not wet the appliance or
put it into water or other liquids.
• The tube may be rinsed and suitably dried.
• All the components, with the exception of the motor body
(10), the mains adaptor (18), the valve (5), the membrane
(1), the silicone cover (3) and the tube (17) may also be
washed in a dishwasher using a delicate programme. This
washing method, which is more aggressive than hand
washing, may discolour or dull and degrade the material
over time.
• Also clean and sanitise the feeding bottle (6) and its acces-
sories (7)-(8), according to the instructions included with
the bottle.
• After washing, always store the product in a clean, dry
place.
*Excluding the motor body (10), mains adaptor (18) and the
silicone tube (17).
ACCESSORIES:
- NaturalFeeling 150 ML feeding bottle REF 00080711000xxx
/ REF 00080811000xxx.
- NaturalFeeling Milk Container REF 00002257200000
- Where XXX=variable identification code identifying the
country of sale.
- Two nursing pad to be used only to absorb excess
breast milk are supplied free with the appliance (REF
20061770000).
• No accessories other than those recommended must be
used.
22