Publicité
Les langues disponibles
Les langues disponibles
WARNING: To reduce the risk of fire, this dryer MUST BE
EXHAUSTED OUTDOORS.
IMPORTANT: Observe all governing codes and ordinances.
In Australia and New Zealand, refer to AS/NZS 5601.1 – Gas
Installations.
n Following these venting requirements will minimise ducting
air noise.
n Adequate ventilation has to be provided to avoid the backflow
of gases into the room from appliances burning other fuels,
including open fires (i.e. available airflow into the room should
match airflow out from the room).
n Dryer exhaust must not be connected into any gas vent,
chimney, wall, ceiling, attic, crawlspace, or a concealed space
of a building. Only rigid or flexible metal vent shall be used for
exhausting.
n Do not use an exhaust hood with a magnetic latch.
102 mm (4") Heavy, Metal Exhaust Vent
n Only a 4" (102 mm) heavy, metal exhaust vent and clamps may
be used.
n Do not use plastic or metal foil vent.
n Exhaust air must not be discharged into a flue which is used for
exhausting fumes from appliances burning gas or other fuels.
n Forced ventilation of fresh air is required.
n Exhaust air must be exhausted to the outside to avoid
suffocation.
n If exhaust is connected to a commonly used exhaust system,
it is required to install flap valves at each connection or
alternative adequate countermeasures.
n Exhaust air must not be connected to an exhaust channel
of a furnace.
DRYER VENTING REQUIREMENTS
Rigid metal vent:
n Recommended for best drying performance and to avoid
Flexible metal vent: (Acceptable only if accessible to clean)
n Must be fully extended and supported in final dryer location.
n Remove excess to avoid sagging and kinking that may result in
n Do not install in enclosed walls, ceilings, or floors.
n The total length should not exceed 7
n An exhaust hood should cap the vent to keep rodents and
NOTE: If using an existing vent system, clean lint from entire length
of the system and make sure exhaust hood is not plugged with
lint. Replace plastic or metal foil vents with rigid metal or flexible
metal vents. Review "Vent System Chart" and if necessary, modify
existing vent system to achieve best drying performance.
Elbows:
n 45° elbows provide better airflow than 90° elbows.
n Plan installation to use the fewest number of elbows and turns.
n Allow as much room as possible when using elbows or making
n Vent outlet is located at the center of the bottom dryer back.
102 mm
(4")
n The vent can be routed up, down, left, right, behind the dryer,
Clamps:
n Use clamps to seal all joints.
n Exhaust vent must not be connected or secured with screws
crushing and kinking.
reduced airflow and poor performance.
insects from entering the building.
Good
turns. Bend vent gradually to avoid kinking.
or straight out the back of the dryer.
or other fastening devices that extend into interior of duct and
catch lint. Do not use duct tape.
⁄
ft. (2.4 m).
3
4
Better
15
Publicité
