Create PIZZA MAKER PRO 12 Manuel D'instructions page 7

• Before each use, check the tightness of all gas supply connections. Do
not use the appliance until all connections have been checked and there
are no leaks.
• Do not smoke during the leak test. Never carry out the tightness test if
there is an open flame.
• When turning on the oven, keep your face and hands as far away from
the appliance as possible.
• The appliance must be installed with a distance from combustible mate-
rials greater than 609 mm (24 inches) on the sides.
• The user must not alter or modify any part of the appliance, as it may
pose a safety risk and will void the warranty.
• Cylinder size: maximum diameter -350mm, maximum height -400mm.
• The appliance must be installed with sufficient ventilation to avoid unac-
ceptable concentrations of harmful substances in the room where it is
installed.
• The minimum distance between the appliance and adjacent walls is
0.5 M.
• The appliance hose must not exceed 1.5 M.
• The appliance must be installed in a well ventilated room. Make sure the-
re is a permanent supply of fresh air and that there is no accumulation of
unburned gases.
• The gas supply pipe or hose must comply with current national require-
ments, must be periodically inspected and replaced if necessary.
• The hose must comply with the en16436 standard.
• The regulator must comply with the en16129 standard.
• Regulator and hose assembly may not be supplied with the appliance in
some regions.
• Check and clean the inside of the oven before turning it on to avoid the
emission of fire by the oils that may have accumulated during the previo-
us cooking.
• Check the burner outlets to make sure they were not clogged during the
previous cooking.
• Regularly clean the burner outlets with a soft metal brush to avoid clog-
ging and allow good combustion.
• Make sure that the connecting hose is not kinked or pinched.
Inspect the gas supply hose before turning on the gas. If there are signs of cut, wear or abra-
sion, it must be replaced before use. Screw the regulator onto the gas bottle. Check the hose
and regulator connections with a soap and water solution before turning on the oven.
BEFORE TURNING IT ON
E NGLI SH
7