Create PIZZA MAKER PRO 12 Manuel D'instructions page 10

4. Connect the hose to the cylinder.
WARNING Always keep the cylinder in an upright position.
The size of the 9L cylinder is 31cm in diameter and 45.5cm high.
If you are not using the appliance, you must turn off the gas from the bottle.
The cylinder used must include a collar to protect the valve.
The minimum distance between the oven and the 9L cylinder is 1m.
B UTA N E G AS R EGU L ATO R
This type of regulator has a press fit.
Make sure the black switch is horizontal.
Squeeze the base and push the regulator
onto the cylinder valve until it clicks.
C O NNECT TH E LP G AS CYLI ND E R
To connect the gas cylinder:
1. The cylinder valve should be in the OFF position.
2. Make sure the oven control knob is in the OFF position.
3. Inspect the valve connections, port, and regulator assembly. Remove dirt and inspect hose
for damage.
4. When connecting the regulator assembly to the cylinder valve, use your hand to tighten
the nut clockwise until it stops. Using a wrench could damage the quick coupling nut and
cause a hazardous situation.
5. Fully open the cylinder valve by turning the regulator counterclockwise.
6. Before turning on the oven, use a soap and water solution to check any of the connections
for leaks.
7. If a leak is found, close the cylinder valve and do not use the oven until your local supplier
can make repairs.
D ISC ON N ECT THE LP G AS CYLI NDE R
1. Turn off the oven and make sure the oven is cool.
2. Close the cylinder valve by turning the regulator clockwise until it stops.
3. Detach the regulator from the cylinder valve by turning the quick coupling nut counter-
clockwise.
4. Put a dust protection cap on the cylinder valve outlet whenever you are not using it.
E NGL I SH
10
L P G AS REG U L ATO R
This regulator has a threaded coupling that
is adjusted by turning it counterclockwise.
Make sure the cylinder is completely off
and screw the regulator as far as possible
onto the cylinder valve.